It is important to read all the instructions thoroughly before beginning set up.
*Please do not plug in the RTX Repeater until instructed
If you make a mistake you will need to reset the RTX Repeater, please follow these instructions:
1. Power off RTX Repeater
2. Power on the RTX Repeater for between 1-5 secs (ie 2 secs) then power off
3. Power on RTX Repeater for between 25-35 secs (ie 30 secs) then power off
Now the RTX Repeater should be reset
Installation Instructions:
*You will need to use a registered handset to perform all key presses in the instructions
1. Place the RTX Repeater near the Gigaset base station.
2. Put the Gigaset base station into Repeater Mode > Settings (Spanner) > System > Repeater Mode - TICK
3. Now plug the power into the RTX 4002 Repeater for 1-5 seconds (ie 2 secs) and turn it off again; then turn it back on
*The LED on the RTX 4002 flashes SLOWLY showing that it is now in registration mode
*If the LED does not flash slowly RESET repeater and start again
4. Now you need to put the Gigaset Base Station into Registration mode please use one of the following steps:
a. In the Web GUI, go to Management > Miscellaneous > Start Registration
b. On a Gigaset Base Station, press and hold the PAGE/FIND button for approximately 3-5 seconds (ie 2 secs)
c. On a Gigaset DX800A press the square Menu Button > Settings (Spanner) > Registration > Register Handset
*The LED on the RTX 4002 Repeater will now flash quickly to show that it is in ‘learn’ mode
5. Using a Registered DECT handset press n * (where ‘n’ is a number between 2 and 7 - This relates to the number of repeaters on the same Base Station) and the green SEND button (Green Telephone). The LED will now flash according to the repeater number you selected. WAIT until the Repeater starts to flash quickly and now press * and then the green SEND (Green Telephone) again to SAVE. The LED should now show a steady light without flashing
*If the LED goes back to flashing quickly then the new settings have not been saved or accepted by the RTX 4002 Repeater. Repeat item 5. If the LED goes back to flashing quickly again then repeat item 5 with a different 'n'
6. Now place the RTX Repeater where you require
*The RTX Repeater needs to be with in range of the Gigaset Base Station